HVAC Repair in Batesville, MS
Homes here need heat from November through March and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Panola County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of work, on a system that can lose power
Batesville gets only a couple of months a year where the system just sits idle. Heat runs November through March, cooling runs May through September, and summer afternoons averaging 90°F push the compressor hard for five straight months. Almost half the homes here heat with electricity, so that same electrical system carries the load all winter too, on nights averaging 35°F.
That matters because storms hit that power. Panola County has logged 35 damaging wind events and 10 winter storms over the past ten years, and statewide, close to a third of households went at least 24 hours without power in 2024. A furnace or heat pump that loses power does not always come back on working right. If your system is short-cycling, heating or cooling unevenly, or will not restart after the power does, that is worth having a contractor look at.
- 5 months
- November through March, your system heats
- 5 months
- May through September, it cools
- 35°F
- the average winter night it heats against
- 90°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Mississippi requires HVAC contractors to hold a state license.
Mississippi tests contractors before they are licensed, and the board keeps that contractor on file. The license belongs to the contractor, not to this repair or any single job, so what is on record with the state is the person or company doing the work.
For a heating and cooling repair, that license is what stands behind the person working on your system. If the repair involves a gas connection, that connection is the part that has to be right, since a leak there is the real danger in this kind of work. In Mississippi, the license is what tells you the contractor has already been tested and is known to the state.
Source: Mississippi State Board of Contractors
- Why is my heat not working?
- Start with the thermostat. Make sure it is set to heat and set a few degrees above room temperature, and check that it has power if it uses a screen or batteries. If the thermostat looks right, check the breaker box for a tripped switch, since furnaces and heat pumps both run on electricity even when the heat itself comes from gas. If the system uses gas, check that the gas valve is open and any switch near the furnace is on. Winter nights here average 35°F, so a furnace that will not start can turn a house cold fast, and if none of this brings the heat back a contractor needs to look at the igniter, the flame sensor, or the control board.
- Why is my system running but not cooling the house?
- Check the air filter first. A filter clogged with dust blocks airflow across the coil, and a coil that cannot move enough air will not pull heat out of the house even though the blower is running. Check that the thermostat is set to cool and set below room temperature, and make sure nothing is blocking the outdoor unit outside, like grass clippings or leaves packed against the coil. Summer afternoons here reach 90°F, so a system moving air but not cooling it usually points to a refrigerant leak or a frozen coil, and both need a contractor to diagnose.
- What can I check before calling for HVAC repair?
- Check the thermostat settings, the batteries in it if it has them, and the breaker box for a tripped switch. Check the air filter and replace it if it looks gray or packed with dust, since a blocked filter can cause problems that look like bigger failures. Look at the outdoor unit and clear away anything piled against it, leaves, grass, or ice. If the system still is not heating or cooling right after that, a licensed Mississippi HVAC contractor can diagnose what the checks did not fix.