A grey air-source heat pump outdoor unit mounted on a concrete pad next to a modern white-rendered residential house.

Heat Pump Installation in Batesville, MS

A new system here will heat from November through March and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Panola County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A gray outdoor HVAC condenser unit mounted on a concrete pad in the front yard of a two-story suburban house.

Ten months of work a year for your heat pump

Batesville asks a heat pump to run nearly year round. Winter nights average 35°F from December through February, and summer afternoons average 90°F from May through September. That is ten months where the system is either the only thing keeping the house warm or the only thing keeping it cool.

A heat pump installed here now has to meet federal minimums of 14.3 SEER2 for cooling and 7.5 HSPF2 for heating if it's a split system built after January 2023. With almost half of homes in the area heating with electricity, that heating side matters as much as the cooling side does. And with ten winter storms and thirty-five damaging wind events recorded here over the past decade, a new install is worth pairing with a plan for what happens if the power goes out.

5 months
November through March, your system heats
5 months
May through September, it cools
35°F
the average winter night it heats against
90°F
the average summer afternoon it cools against
Isometric illustration of a cutaway house showing interior rooms, ceiling ductwork and an air handler, connected by lines to an outdoor condenser unit on a pad beside the building.
Your system heats November through March and cools May through September.

NOAA nClimDiv, 1991–2020 normals

Mississippi requires HVAC contractors to hold a state license.

The license belongs to the contractor, not to this one job, so it carries over from one installation to the next. The State Board of Contractors is the body that issues it and keeps the record.

For this job, that license is what stands behind the person doing the work. In most cities and counties, setting a heat pump also needs a permit from the local building office, with an inspection once the work is done. That inspection checks the installation itself, not the contractor, and it comes from the local office rather than the state.

Source: Mississippi State Board of Contractors

Is a heat pump better than a furnace?
It depends on what you're comparing it to. A heat pump does both heating and cooling, so it replaces your furnace and your air conditioner in one system. Here, homes need heat from November through March and cooling from May through September, so a single system running most of the year has more to do than a furnace that only runs in winter. A furnace paired with a separate air conditioner can still heat a home just as well, and burns gas or propane rather than running on electricity like a heat pump does.
What's the difference between a heat pump and an air conditioner?
An air conditioner only cools. A heat pump cools the same way an air conditioner does, but it can also run in reverse to heat your home. Both move heat rather than making it, using a compressor and refrigerant, and both have to meet the same federal efficiency minimums, 14.3 SEER2 for cooling. A heat pump adds 7.5 HSPF2 for heating on top of that, since it's doing a second job the air conditioner never does.
Does a heat pump work in cold weather?
Yes. A heat pump pulls heat from the outside air even when it's cold, and it keeps working down to temperatures well below what winter nights here reach. Winter lows here average 35°F from December through February, which is well within the range a heat pump handles without help. In much colder climates a heat pump may need backup heat for the coldest stretches, but that's not what winters here call for.