A tabby cat sleeps curled up on a dark grey bed in a modern bedroom equipped with a wall-mounted air conditioning unit.

Mini Split Installation in Pearl, MS

A new system here will heat from November through March and cool from May through October every year. Tell us about the house, and a licensed contractor who covers Rankin County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An orange cat sleeps on a neatly made bed with dark grey bedding in a minimalist bedroom with wall sconces and a mounted air conditioner.

Eleven months of work for a Pearl mini-split

A mini-split in Pearl runs almost year round. Homes here need cooling from May through October, then heat from November through March, so the system only gets a few weeks of rest a year. Summer afternoons average 91°F, which keeps the compressor working hard all season, and winter lows near 37°F mean the heat pump side is doing real work too, not just backing up a furnace.

Any mini-split installed new has to meet the federal minimum for split-system heat pumps, 14.3 SEER2 for cooling and 7.5 HSPF2 for heating. Mississippi also sees its share of power loss, with 30% of households going at least 24 hours without power in 2024, and the area has logged 213 damaging wind events over the past ten years. Worth asking your contractor how the unit you choose handles a restart after the power drops.

5 months
November through March, your system heats
6 months
May through October, it cools
37°F
the average winter night it heats against
91°F
the average summer afternoon it cools against
Isometric illustration of a cutaway house with a dark tiled gable roof, showing two wall-mounted indoor split air conditioning units connected by lines to an outdoor condenser unit on the ground outside.
Your system heats November through March and cools May through October.

NOAA nClimDiv, 1991–2020 normals

Mississippi requires HVAC contractors to hold a state license.

The license comes from the State Board of Contractors, and it covers the contractor, not the job itself. Anyone doing HVAC work in Mississippi is supposed to hold that license before they take on a mini-split install.

For the install itself, the local building office is what stands behind the work. Most cities and counties require a permit for a job like this and send someone out to inspect it once it's done, so the wiring and the line set get a second look beyond the contractor's own word.

Source: Mississippi State Board of Contractors

Is a mini split worth it?
For most homes here, yes, because a mini split handles both jobs, heat from November through March and cooling from May through October. That is 11 months a year of use out of one system. It also gives you control room by room instead of heating or cooling the whole house at once, which matters if some rooms sit empty during the day.
How many rooms can a mini split cover?
A single outdoor unit can run one indoor head or several, depending on the system. Single-zone systems cover one room. Multi-zone systems can run four or five indoor heads off one outdoor unit, each with its own thermostat. A contractor sizing the job will look at the square footage and layout of the rooms you want covered before recommending how many zones to run.
Can a mini split heat a whole house?
It can, if enough zones are installed to reach every room, but a lot depends on how the house is laid out. Winter lows here average 37°F, so the heat pump needs to be sized to keep up on the coldest nights, not just the mild ones. A contractor can work out how many indoor units the house needs and where they should go to heat it evenly.