A grey outdoor HVAC unit mounted on a concrete pad beside the beige-sided exterior wall of a suburban house.

Heat Pump Installation in Amory, MS

A new system here will heat from November through March and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Monroe County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An outdoor heat pump unit mounted on a concrete pad beside a house with beige siding and a landscaped garden bed.

Ten months of work a year in Amory

A heat pump here runs from November through March for heat, then May through September for cooling. That is ten months of the year with only a short break in spring and fall. Winter nights average 35°F, mild compared to a lot of the country, but summer afternoons push past 90°F, and the same unit has to answer both.

Most homes in this area heat with electricity, so the heat pump is doing that work alone on cold nights, not backing up a furnace. Any split-system heat pump installed new has to meet 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, a floor set by federal rule since January 2023.

5 months
November through March, your system heats
5 months
May through September, it cools
35°F
the average winter night it heats against
90°F
the average summer afternoon it cools against
Isometric cutaway illustration of a single-story house showing interior rooms with furniture, an attic duct network connected to a furnace or air handler, and an outdoor condenser unit linked by lines outside the wall.
Your system heats November through March and cools May through September.

NOAA nClimDiv, 1991–2020 normals

Mississippi requires HVAC contractors to hold a state license.

The state board tests the contractor before issuing that license and keeps a record of who holds one. It covers the contractor as a business, not the specific heat pump going into your home in Monroe County, so the license tells you this person met the state's bar to do the work, not that this particular job was checked off by anyone.

That check comes from the local building office instead. A heat pump installation in most cities and counties needs a permit before the work starts and an inspection once it's done, and that inspection is what confirms the unit went in correctly. The license and the permit do two different jobs. One says the contractor is qualified. The other says this installation was looked at.

Source: Mississippi State Board of Contractors

Is a heat pump better than a furnace?
A heat pump does something a furnace can't. It cools your home in summer and heats it in winter, all from one system. A furnace only heats. With five months of cooling and five months of heating here, that difference matters. A furnace paired with a separate air conditioner will push harder in very cold weather, but a heat pump built to current standards handles winter lows in the 30s without trouble.
What's the difference between a heat pump and an air conditioner?
An air conditioner only moves heat out of your home. A heat pump does that too, but it can also run in reverse and move heat into your home, which is what heats the house in winter. Mechanically they're close cousins. An air conditioner needs a furnace or some other heat source to get through the cold months, while a heat pump covers both jobs on its own.
Does a heat pump work in cold weather?
Yes. A heat pump pulls heat from the outside air even when it's cold, and current models are rated to do that well below freezing. Winter nights here average 35°F, which is well within what a heat pump handles without needing backup heat to step in.